Do you really feel bad for your touch lamp that does not work properly and need to know how to fix a touch lamp? Then don’t worries we make this guide for you take a close look and try to fix your touch lamp easily.
What is a touch lamp?
A touch lamp is a lamp that turns on and off by touching it with your fingertips. A simple touch is enough. This lamp, therefore, has no switch on its cord. But how is this possible? It’s not magic, and rest assured it’s absolutely safe. These lamps comply with European standards for safety and insulation. The operation is simple. By touching the base of the lamp our body acts as a switch. In fact our body, by earthling it sends a signal to the lamp which will light up, go out or for some models equipped with a dimmer light up more or less loudly. Obviously the current which passes in the body is of a few microamperes, therefore imperceptible and absolutely without any danger.
Why use a touch lamp?
A touch lamp can be used in many cases. Designers are using this solution more and more because it has many advantages, suddenly this type of light is no longer only used as a bedside lamp, even if it is still the first use.
How to fix a touch lamp
Touch dimmers are operated by your body. Your body acts as an antenna, or the conductor, and touching any part of the metal on the lamp — coupled with the 60 Hz circuit — causes the lamp to turn on or off or dim. The Convenience A tactile operating light makes it a good choice as a reading bedside lamp — Easy Off, Easy On. Try fixing your touch lamp if it is no longer working rather than screwing up it.
Instructions
- Unplug the lamp from the wall outlet.
- Remove the bottom of your lamp. Use a flathead screwdriver to pry off the bottom of the lamp, exposing the wiring and touching dimmer.
- Remove the touch dimmer control from your lamp. Remove the nuts that connect the touch dimmer control to your lamp by untwisting them. If your dimmer switch will be wired — connected without wire nuts — to the lamp, use wire cutters or strippers to cut the wires as close as you can to the touch dimmer control. If you need to cut the wires, you will need to strip 1/2 inch of insulation from each wire.
- Place the yellow wire of the new dimmer button on the lamp. The yellow wire has a ring attached to the end and slides over the threaded fitting at the base of the lamp. Locate the nipple by locating where the lamp wire threads through the lamp body. The old yellow wire from the old dimmer will be connected here. Use pliers to loosen the nut on the threaded fitting; remove the nut and the old yellow wire. Thread the lamp wire through the loop on the yellow wire of the new touch control dimmer and place the loop over the threaded fitting. Replace the nut on the threaded connection and tighten it firmly.
Connect the black wire from the dimmer to the hot wire lamp cord. Your dimmer control will have four wires: black, white, yellow with a brass ring on the end, and an additional wire which will be either gray or red. Lamp wire is not color-coded and is usually colored to match the lamp or to be as unobtrusive as possible. The hot wire of your lamp will be smooth, while the neutral wire will be ribbed. Good wire — or hot — wire that connects to the outlet by turning an orange wire nut on it and the black wire from the dimmer control.
- Connect the white neutral wires together. Connect the ribbed neutral wire that connects to the jack, the ribbed neutral wire that connects to the lamp socket, and the white wire from the dimmer control together by turning an orange wire nut on them.
- Connect the red or gray wire to the lamp socket hot wire. Locate the smooth hot wire that connects to the lamp socket and wires to the red or gray wire from the attenuator control by twisting them with an orange wire nut.
- Put the bottom of the lamp back on the lamp base and plug your lamp into the wall outlet.
Conclusion: Before doing any electric work ensure your safety purpose, if you don’t know how to fix a touch lamp, then don’t hesitate, feel free to call an expert electrician to fix your lightening problem.